CAR rate limiting
Hi,
I think this would do it
access-list 150 permit tcp any any
class-map match-any tcp match access-group 150 class-map match-any www match protocol http ! ! policy-map test class www police cir 100000 class tcp police cir 500000
interface GigabitEthernet0/0 ip address 162.10.9.6 255.255.255.0 ip rip authentication mode md5 ip rip authentication key-chain rip duplex auto speed auto service-policy output test
Or instead you could set an ACL to match port 80 (www) instead of nbar.
Tim Gregory Network Administrator University of Lincoln Brayford Pool Lincoln LN6 7TS
01522 886566 tgregory@lincoln.ac.uk
—–Original Message—– From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of Paul Dardinski Sent: 09 August 2006 12:44 To: Cisco certification Subject: CAR rate limiting
If required for example to limit www traffic to rate x and limit tcp traffic to rate y, is this possible using continue via CAR?
Can anyone provide an example config for this?
Ie. limit www to 100k, tcp to 500k?
Category: CCIE Study
