Hi Angelo,
Yes mine also wouldn’t ping from the serial interface of the spoke. I don’t think there would be many scenarios where you would need to be able to snd multicast traffic from there but to allow this through I think you would need to put another mroute statement on the hub because the RPF […]
Hi Sabrina,
Thank you so much for you very detailed & comprehensive email. I understand now, and have it working on my equipment. I was experiencing the RPF failure and didn’t understand why I needed the mroute, but now I see.
Thanks again, everything has clicked into place in my mind Peter
[…]
OK, one step at the time. Let me show you what I see an my routers **** On my Spoke2 router I have: CFG: —– ip multicast-routing interface Loopback0 ip address 150.1.1.1 255.255.255.0 ip pim sparse-mode ip […]
Hi, let me see if I understood right. Spoke 1 is the RP and is also the router from where you want to ping Spoke 2 is the router that is joining the group. If yes, then I believe your problem may be the following. When […]
Forget it…I saw your reference to the IEWB lab only later….you have area0 in your network and that should be good enough… You are not redistributing connected on SW1 as well, are you? Sabrina
—– Original Message —- From: sabrina pittarel To: Daniel Fredrick Cc: ccielab@groupstudy.com Sent: Wednesday, […]
I could do that, but you only need area 0 when you area talking between two different areas right?
But yeah the reason why I bring this question up is that every once in awhile this will happen, where connected routes are not redistributed… even when they are included in the network statement.
Thanks, Dan
On 9/13/06, […]
Try to make your OSPF area to be area 0 Sabrina
—– Original Message —- From: Daniel Fredrick To: sabrina pittarel Cc: ccielab@groupstudy.com Sent: Wednesday, September 13, 2006 7:21:56 AM Subject: Re: Redistributing ODR and RIP
f0/24 - 204.12.1.7/24 | […]
f0/24 - 204.12.1.7/24 | (sw1) 173.1.137.0/24 (R1)
=== SW1 config ===
interface FastEthernet0/24 no switchport ip address 204.12.1.7 255.255.255.0
interface Vlan137 ip address 173.1.137.7 255.255.255.0
router rip version 2 redistribute ospf 1 metric 1 offset-list 1 in […]
Peter,
Please look at this thread: http://www.groupstudy.com/archives/ccielab/200510/msg00191.html
& for an explanation about the OIL Null you mention please look at this thread http://www.groupstudy.com/archives/ccielab/200606/msg00861.html
Regards Victor.-
—–Mensaje original—– De: nobody@groupstudy.com [mailto:nobody@groupstudy.com] En nombre de Peter Cresswell Enviado el: Miircoles, 13 de Septiembre de 2006 04:16 a.m. Para: ’sabrina pittarel’; ccielab@groupstudy.com Asunto: RE: Hub & Spoke Multicast problem
Hi Sabrina,
I […]
Hi Sabrina,
I tried that sourcing from both my loo0 and eth0/0 (which i put into sparse-dense-mode) and still no good.
I don’t understand why my OIL’s are all saying null?? Do you know what would cause this? In nbma mode i would have expected to see and OIL with Ser0/0 and the IP of Spoke2.
Thanks, […]